Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › THROTTLE BODY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014974 THROTTLE BODY A

3SZ-VE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (w/ Heater Hose)

Hide 78180P 4.DISCONNECT ACCELERATOR CONTROL CABLE ASSEMBLY

a.
A126584

Loosen the nut shown in the illustration, then disconnect the accelerator control cable.


Hide 22210 5.REMOVE THROTTLE BODY ASSEMBLY

a.
A268911

Disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose (w/ Heater Hose).


b.
A266316C01
0.354,1.01 0.354,1.354 true 0.271,1.406 0.656,1.76 0.385,0.354 10 *1
*1 No. 2 Ventilation Hose


Disconnect the throttle position sensor connector.


c.

Disconnect the idle speed control actuator connector.


d.

Disconnect the No. 2 ventilation hose.


e.
A266317

Remove the 2 bolts and No. 2 throttle body bracket .


f.
A126587

Remove the bolt and separate the engine wire harness bracket from the throttle body assembly.


g.
A126588

Remove the 2 bolts and the throttle body assembly.


h.

Remove the O-ring from the intake manifold.