Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › SFI SYSTEM(w/o Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014987 SFI SYSTEM(w/o Rear Heated Oxygen Sensor) C

3SZ-VE ENGINE CONTROL  SFI SYSTEM(w/o Rear Heated Oxygen Sensor)  P0603  Internal Control Module Keep Alive Memory (KAM) Error  


DESCRIPTION

The transponder key computer assembly (immobiliser ECU) ensures security by controlling the START/END of the communication of matching codes with the ECM. It does so in accordance with ignition ON/OFF status and the immobiliser SET/ UNSET status. If the communication cannot be matched due to a malfunction in the ECM, a DTC is recorded.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0603 Internal Control Module Keep Alive Memory (KAM) Error Rolling codes cannot be overwritten into ECM
(1 trip detection logic)
ECM - DTC stored

WIRING DIAGRAM

A268106E02
0.281,3.781 0.885,3.99 0.604,0.208 10 E58 0.281,3.969 2.875,4.208 2.594,0.24 10 TRANSPONDER KEY ECU 6.208,3.781 6.813,3.99 0.604,0.208 10 E3 6.208,3.958 7.135,4.396 0.927,0.438 10 ECM 0.802,1.448 1.438,1.646 0.635,0.198 10 SIO2 0.969,2.031 1.26,2.25 0.292,0.219 10 E 1.271,1.365 1.552,1.563 0.281,0.198 10 9 1.25,1.948 1.708,2.333 0.458,0.385 10 14 6.021,1.458 6.656,1.656 0.635,0.198 10 SIO2 5.677,1.385 6.104,1.708 0.427,0.323 10 32

PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / DTC.

Powertrain > Engine > Trouble Codes
50001 206

e.

Read DTCs.

HINT:

If P0603 is detected, this indicates that the engine computer is malfunctioning. Replace the engine control computer.


Result:
Result Proceed to
No output A
P0603 (for LHD) B
P0603 (for RHD) C




A

B

C