This circuit operates the spool valve by means of the duty signal from the ECM so as to switch the oil passages to the advanced side or retarded side to activate the VVT controller (camshaft timing sprocket assembly). In this way, optimum valve timing is maintained.
When the engine is stopped, the camshaft timing oil control valve is set to the most retarded position.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0010 | Camshaft Position "A" Actuator Circuit (Bank 1) | Open or short in camshaft timing oil control valve circuit for 8 second or more
(1 trip detection logic) |
·
Open or short in camshaft timing oil control valve circuit ·
Camshaft timing oil control valve assembly ·
ECM |
Comes on | DTC stored |
Read freeze frame data using the intelligent tester or Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester or Techstream on.
Clear DTCs after recording the freeze frame data and DTCs.
Start the engine.
Allow the engine to idle and check for DTCs.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read DTCs.
| Result | Proceed To |
|---|---|
| P0010 | A |
| No output | B |
A
B
Inspect the camshaft timing oil control valve assembly.
Click hereEngine / Hybrid System>3SZ-VE ENGINE CONTROL>CAMSHAFT OIL CONTROL VALVE>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C21-1 - C23-6 (OCV+) | Always | Below 1 Ω |
| C21-2 - C23-5 (OCV-) | Always | Below 1 Ω |
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C21-1 or C23-6 (OCV+) - Body ground | Always | 10 kΩ or higher |
| C21-2 or C23-5 (OCV-) - Body ground | Always | 10 kΩ or higher |
Reconnect the camshaft timing oil control valve assembly connector.
Reconnect the ECM connector.
| Result | Proceed To |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C