When the engine stalls after starting, DTC is output. To grasp the situation when DTC is output, the freeze-frame data can be checked by using the intelligent tester or Techstream. Because the engine running conditions when it stalls can be checked by using the freeze-frame data, vehicle maintenance services can improve. Moreover, because an engine stall due to lack of fuel is also detected, the fuel must be checked before operation. (An engine stall may be detected due to cranking, even if the engine does not stall.)
| DTC No. | Detection Item | DTC Detection Condition | MIL | Memory |
|---|---|---|---|---|
| P1603 | Engine Stall History | After monitoring for startability problems (P1604) finishes and 5 seconds or more elapse after starting the engine, with the engine running, the engine stops without the ignition switch being operated.
(1 trip detection logic) |
- | DTC stored |
When other DTCs are displayed, first troubleshoot the corresponding DTC.
Because DTC P1603 differs from the conventional DTC, the following procedure is described as an example.
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester or Techstream on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
|---|---|
| P1603 | A |
| P1603 and other DTCs | B |
A
B
Using the time series freeze-frame data, check the data when and after the DTC is detected, to be used for troubleshooting.
Connect the intelligent tester or Techstream to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester or Techstream on.
Check the time series freeze-frame data following the instructions displayed on the intelligent tester or Techstream, and check the vehicle conditions when the engine stalls.
Check the freeze-frame data whether the engine was cool or warmed up.
| Coolant Temp | Initial Engine Coolant Temp |
Using the freeze-frame data, check whether the engine was idling, running at a constant speed, decelerating, accelerating, starting and stopping.
| Engine Speed | ISC STEP Position |
| Vehicle Speed | ISC Duty |
| Throttle Sensor Position | Shift Signal |
| Throttle Position | Stop Light Signal |
Check the feedback performance state.
| Fuel System Status (Bank 1) | Total Fuel Trim |
| Short FT #1 | O2S B1 S1 |
| Long FT #1 | O2S B1 S2 |
Check the freeze-frame data of the engine load/electric load.
| Calculate Load | A/C Signal |
| Electrical Load Signal | Power Steering Signal |
Check the freeze-frame data of the fuel injection.
| Injection Volume | Injection Time |
Referring to the above freeze-frame data, perform the reproduction test.
Based on the freeze-frame data and the reproduction test, specify the malfunctioning section while comparing to the reference values shown in the ECM data list description.
| Result | Proceed to |
|---|---|
| The malfunctioning section can be specified. | A |
| The malfunctioning section can not be specified. | B |
A
B