Home › Engine / Hybrid System › 3SZ-VE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002969 3SZ-VE ENGINE MECHANICAL _0014995 FRONT CRANKSHAFT OIL SEAL A

3SZ-VE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

Hide 13471 3.REMOVE CRANKSHAFT PULLEY

a.
A261730C04
1.479,1.354 0.979,1.833 0.979,1.833 0.823,1.531 true 0.292,1.458 0.563,1.458 false 3.094,1 3.427,1.385 0.333,0.385 10 *a 0.115,1.375 0.552,1.708 0.438,0.333 10 *b 0.844,1.875 1.458,2.177 0.615,0.302 10 SST
*a Turn
*b Hold


Using SST, hold the crankshaft pulley and loosen the crankshaft pulley bolt.

SST
09330-00021  (91651-60855)
09213-54015  

SST
09330-00021  


b.
A261731C04
1.271,0.979 0.677,0.979 true 0.51,1.813 0.75,1.813 false 3.125,1.229 3.396,1.656 0.271,0.427 10 *a 0.781,1.729 1.24,2.073 0.458,0.344 10 *b 0.375,0.896 1.031,1.323 0.656,0.427 10 SST
*a Turn
*b Hold


Using SST, remove the crankshaft pulley bolt and the crankshaft pulley.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05010, 09954-05021)


Hide 11302A 4.REMOVE TIMING CHAIN OR BELT COVER OIL SEAL

a.

Using a knife, cut off the timing chain or belt cover oil seal lip.


b.
A261491C04
0.542,1.063 0.479,1.344 true 1.844,0.885 2.135,0.604 true 0.479,0.885 1.031,1.208 0.552,0.323 10 *a 2.115,0.458 2.531,0.875 0.417,0.417 10 *1
*1 Protective Tape
*a Cut Position


Using a screwdriver with its tip wrapped in protective tape, remove the timing chain or belt cover oil seal.

NOTICE:

After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.