Home › Engine / Hybrid System › K3-VE FUEL › FUEL PUMP › 2011.11–2014.04
RM19Y0E _51 Engine / Hybrid System _002972 K3-VE FUEL _0015022 FUEL PUMP A

K3-VE FUEL  FUEL PUMP  INSTALLATION  


PROCEDURE

Hide 23210P 1.INSTALL FUEL PUMP WITH MOTOR AND BRACKET ASSEMBLY

a.

Install a new gasket onto the fuel pump with motor and bracket assembly.


b.
A142212
2.896,1.708 2.323,2.031 true 2.979,0.885 2.958,1.552 true 2.906,0.708 3.125,0.906 0.219,0.198 10 *a 2.156,1.948 2.375,2.135 0.219,0.188 10 *b
*a Protrusion
*b Concave


Align the protrusion of the fuel pump with motor and bracket assembly with the hole in the fuel pump bracket as illustrated.


c.

Align the protrusion of the fuel pump bracket with the concave of the fuel tank.


d.
A142193
1.823,0.0 1.922,0.152 0.099,0.152 10 3 0.869,0.14 0.968,0.292 0.099,0.152 10 6 0.264,0.926 0.364,1.078 0.099,0.152 10 1 0.622,1.659 0.722,1.811 0.099,0.152 10 4 1.668,1.966 1.768,2.118 0.099,0.152 10 7 2.762,1.687 2.862,1.839 0.099,0.152 10 2 3.211,0.958 3.31,1.11 0.099,0.152 10 5 2.718,0.206 2.817,0.358 0.099,0.152 10 8

Tighten the 8 screws in the sequence shown in the illustration.

Torque:
3.8 N*m (38 kgf*cm, 33 in.*lbf)


e.

Install the clamp onto the fuel tank.


f.

Connect the fuel pump connector.


Hide 77203A 2.INSTALL FUEL SUCTION TUBE SUB-ASSEMBLY

a.
A261543
2.188,0.771 2.969,0.323 true 2.979,0.219 3.167,0.375 0.188,0.156 10 *1
*1 Checker
V100135

Push
V100136

Pull out


Align a new fuel suction tube (fuel tube connector) with the fuel pump tube, then push in the fuel suction tube until the retainer makes a click sound. Then pull out the checker.

HINT:

If connecting the tubes is too tight, apply a light coat of appropriate lubricant or gasoline to the tip of the fuel pump tube.


NOTICE:
·

Check that there are no scratches or foreign matter around the connected parts of the fuel pump tube and fuel suction tube (fuel tube connector) before performing this work.

·

After connecting the fuel suction tube (fuel tube connector), check that the fuel pump tube and fuel suction tube are securely connected by pulling them.




b.

Fit the fuel suction tube into the clamp.


Hide 77100 3.INSTALL FUEL TANK ASSEMBLY