Home › Engine / Hybrid System › K3-VE FUEL › FUEL PUMP › 2011.11–2014.04
RM19Y0E _51 Engine / Hybrid System _002972 K3-VE FUEL _0015022 FUEL PUMP A

K3-VE FUEL  FUEL PUMP  REMOVAL  


PROCEDURE

Hide 77100 1.REMOVE FUEL TANK ASSEMBLY

Hide 77203A 2.REMOVE FUEL SUCTION TUBE SUB-ASSEMBLY

a.
A142182

Separate the fuel suction tube from the clamp.


b.
A130590
1.125,3.344 0.969,3.052 false 1.813,3.292 1.677,2.917 1.677,2.917 2.031,3.292 true 3.063,3.115 2.917,2.865 false 1.917,3.958 1.854,4.167 false 3.219,3.802 3.219,4.125 false 0.51,0.448 1.177,0.229 true 1.208,0.104 1.406,0.25 0.198,0.146 10 *1 0.75,2.948 0.938,3.115 0.188,0.167 10 *3 1.479,2.823 1.667,2.99 0.188,0.167 10 *2 3.135,4.146 3.313,4.313 0.177,0.167 10 *5 1.74,4.188 1.917,4.333 0.177,0.146 10 *4 2.729,2.75 2.917,2.917 0.188,0.167 10 *1
*1 Retainer
*2 O-ring
*3 Nylon Tube
*4 Fuel Tube Connector
*5 Pipe
V100135

Pinch
V100136

Pull out


Pinch the retainer to unlock it as illustrated, then pull the fuel suction tube (fuel tube connector) out of the fuel pump tube.

NOTICE:
·

Remove any dirt and foreign matter from the fuel tube connector.

·

Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel pump tube.

·

Perform this work by hand. Do not use any tools.

·

Do not forcibly bend, twist or turn the nylon tube.

·

Protect the disconnected parts by covering them with a plastic bag after disconnecting the fuel tube connector.

·

As some pressure remains in the fuel line, use a piece of cloth to prevent gasoline splashes.

·

If the fuel tube connector and fuel main tube are stuck, pinch the fuel main tube and push and pull the fuel tube connector to release them.




c.
A142215

Remove the retainer from the fuel pump tube.


Hide 23210P 3.REMOVE FUEL PUMP WITH MOTOR AND BRACKET ASSEMBLY

A261199

a.

Disconnect the fuel pump connector.


b.

Separate the clamp from the fuel tank, then remove the wire harness.


c.
A142193

Remove the 8 screws, then remove the fuel pump bracket.


d.

Remove the fuel pump with motor and bracket assembly from the fuel tank.

NOTICE:
·

Do not damage the fuel pump filter.

·

Make sure that the fuel sender gauge arm does not bend.




e.

Remove the gasket from the fuel pump with motor and bracket assembly.