1.REMOVE ENGINE ASSEMBLY
16507
2.REMOVE RADIATOR PIPE SUB-ASSEMBLY
Disengage the hose clamp.
Remove the 2 bolts and the radiator pipe sub-assembly.
19500
3.REMOVE IGNITION COIL ASSEMBLY
11201
4.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
11213
5.REMOVE CYLINDER HEAD COVER GASKET
Remove the cylinder head cover gasket from the cylinder head cover sub-assembly.
15330
6.REMOVE CAM TIMING OIL CONTROL VALVE ASSEMBLY
Remove the bolt, then remove the cam timing oil control valve assembly.
16173
7.REMOVE WATER PUMP PULLEY
16604B
8.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
Remove the nut, No. 2 idler pulley sub-assembly and idler pulley cover plate.
16603A
9.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY
Remove the nut, No. 1 idler pulley sub-assembly.
13471
10.REMOVE CRANKSHAFT PULLEY
| *a | Timing Mark |
Turn the crankshaft clockwise, then align the timing mark of the crankshaft pulley with the indicator of the timing chain cover.
| *a | Matchmark |
Check that the matchmarks of the camshaft timing sprocket are facing upward.
If not, turn the crankshaft 1 revolution so they face upward (No. 1 cylinder at TDC/ compression).
Using SST, remove the crankshaft pulley.
12101
11.REMOVE OIL PAN SUB-ASSEMBLY
|
Engine Front |
Remove the 11 bolts and 3 nuts.
| *1 | Oil Pan Seal Cutter |
Using oil pan seal cutter, remove the oil pan sub-assembly from the cylinder block.
11302
12.REMOVE TIMING CHAIN OR BELT COVER SUB-ASSEMBLY
Remove the 15 bolts and 2 nuts, then remove the timing chain or belt cover sub-assembly.
11302A
13.REMOVE TIMING CHAIN OR BELT COVER OIL SEAL
| *1 | Protective Tape |
| *2 | Piece of Cloth |
| *3 | Wooden Block |
Using a screwdriver with its tip wrapped in protective tape, remove the timing chain or belt cover oil seal.
19315
14.REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE
Remove the No. 1 crankshaft position sensor plate from the crankshaft.
13545
15.REMOVE CHAIN TENSIONER PLUNGER
Move the stopper plate of the tensioner downward, then push the chain tensioner plunger to the end, keeping it unlocked.
Move the stopper plate upward and lock it. Align the holes of the stopper plate and tensioner, then insert a 2.5 mm (0.098 in.) diameter hexagon wrench.
Remove the bolt and nut, then remove the chain tensioner plunger.
13506
16.REMOVE CHAIN SUB-ASSEMBLY
Remove the 2 bolts and the No. 2 timing chain guide.
Remove the chain sub-assembly.
13566B
17.REMOVE TIMING CHAIN GUIDE
Remove the 2 bolts and the timing chain guide.
13591
18.REMOVE TIMING CHAIN TENSION ARM
Remove the bolt and the timing chain tension arm.
15708
19.REMOVE NO. 1 OIL NOZZLE SUB-ASSEMBLY
Remove the bolt and the No. 1 oil nozzle sub-assembly.
15100
20.REMOVE OIL PUMP ASSEMBLY
Remove the 3 bolts and the oil pump assembly.
Do not drop the oil pump driven rotor as it is not fixed onto the oil pump assembly.