Home › Engine / Hybrid System › 3SZ-VE STARTING › STARTER(for Manual Transmission) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002981 3SZ-VE STARTING _0015071 STARTER(for Manual Transmission) A

3SZ-VE STARTING  STARTER(for Manual Transmission)  REMOVAL  


PROCEDURE

Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 33820B 6.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 33110 8.SUPPORT MANUAL TRANSMISSION ASSEMBLY

a.
C142554

Support the manual transmission assembly with a transmission jack.


Hide 51022 9.REMOVE REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY

a.
A265909

Remove the 6 bolts and the rear engine support member sub-assembly.


Hide 28100 10.REMOVE STARTER ASSEMBLY

a.

Tilt the engine and manual transmission assembly by gradually lowering the transmission jack until the bolts can be seen.

NOTICE:

Do not tilt the manual transmission assembly more than necessary.



b.
A126516

Disconnect the starter connector.


c.

Remove the nut, then disconnect the engine wire.


d.
A126517

Disengage the clamp of the backup light switch.


e.

Hold the transmission.


f.
A126520

Remove the 2 bolts and the starter assembly with the transmission inclined.

HINT:

Use a union nut wrench to loosen the lower bolt.