Home › Drivetrain › A4Q AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002983 A4Q AUTOMATIC TRANSMISSION / TRANSAXLE _0015081 PARK / NEUTRAL POSITION SWITCH A

A4Q AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch assembly to the control shaft.


b.

Temporarily install the bolt.


c.

Temporarily install the transmission control shaft lever.


d.
C153890C05
2.333,0.615 2.833,0.656 true 2.854,0.563 3.271,0.99 0.417,0.427 10 *1
*1 Transmission Control Shaft Lever


Turn the transmission control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.


e.

Remove the transmission control shaft lever.


f.
C153889C05
2.115,0.427 2.75,0.26 true 1.938,1.104 2.854,1.188 true 2.792,0.167 3.25,0.552 0.458,0.385 10 *1 2.885,1.104 3.292,1.521 0.406,0.417 10 *a
*1 Notch
*a Neutral Basic Line


Place a ruler tightly against the notch on the control shaft, and adjust the park/neutral position switch assembly until the neutral basic line becomes parallel with the ruler.


g.

Hold the switch in position and tighten the bolt.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)


h.

Connect the connector to the park/neutral position switch assembly.


Hide 35507D 2.INSTALL TRANSMISSION CONTROL SHAFT LEVER

a.
C153891

Install the transmission control shaft lever and nut.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


Hide 33820B 3.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Set the transmission control shift lever to the N position.


b.

Temporarily install the transmission control cable assembly to the transmission control shaft lever with the bolt.

NOTICE:

Install the transmission control cable assembly with the white paint marks facing up to prevent the inner cable from becoming twisted.



c.

Connect the transmission control cable assembly to the control cable bracket with a new clip.


d.

While holding the shift lever lightly toward the R position side, tighten the bolt.

Torque:
8.4 N*m (85 kgf*cm, 74 in.*lbf)