Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for 3SZ-VE) › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002984 CLUTCH _0015093 CLUTCH MASTER CYLINDER(for 3SZ-VE) A

CLUTCH  CLUTCH MASTER CYLINDER(for 3SZ-VE)  REMOVAL  


PROCEDURE

Hide 45250 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 3.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE

a.
C249125

Disconnect the No. 1 clutch reservoir hose.

HINT:

Use container to collect the fluid.



Hide 31481 4.SEPARATE NO. 1 CLUTCH RELEASE TUBE

a.
C249126

Using union nut wrench (10 mm), separate the No.1 clutch release tube.

HINT:

Use container to collect the fluid.



Hide 55106 5.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)

a.
C250915

Remove the 4 bolts and 4 nuts and remove the brake pedal support sub-assembly.


Hide 6.REMOVE CLUTCH PEDAL BRACKET (for RHD)

a.
C249128

Remove the nut and 2 bolts and remove the clutch pedal bracket.


Hide 31410 7.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

C144705

a.

Remove the clip, wave washer and the pin and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.


b.
C249127

Remove the bolt and nut and remove the clutch master cylinder assembly.