Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › 2011.11–2015.08
RM19Y0E _55 Steering _002998 STEERING COLUMN _0015163 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 84306 2.REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/ Airbag System)

Hide 84312 3.REMOVE HORN CONTACT PLATE (w/o Airbag System)

a.
C249319

Disconnect the connector.


b.
C249314

Disengage the 3 claws and remove the horn contact plate from the steering column assembly.


Hide 89650 4.REMOVE POWER STEERING ECU ASSEMBLY

Hide 89785B 5.REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

Hide 45250 6.REMOVE STEERING COLUMN ASSEMBLY

a.
C229324C02
2.01,0.438 2.406,0.438 2.406,0.438 2.031,0.635 true 2.438,0.354 2.833,0.688 0.396,0.333 10 *a
*a Matchmark


Put matchmarks on the steering intermediate shaft assembly and the steering column assembly.


b.

Remove the bolt on the upper side of the steering intermediate shaft assembly.


c.
C249327

Remove the 2 bolts and 2 nuts.


d.

Pull out the steering column assembly avoiding the EPS motor being caught.

NOTICE:
·

Be careful not to damage the brake booster assembly by hitting with the steering main shaft.

·

Be careful not to damage the steering column hole shield.




Hide 45254 7.REMOVE STEERING COLUMN HOLE SHIELD

a.

Separate the steering column hole shield from the floor panel.