Home › Drivetrain › CLUTCH › CLUTCH SYSTEM(for 3SZ-VE) › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002984 CLUTCH _0015098 CLUTCH SYSTEM(for 3SZ-VE) N

CLUTCH  CLUTCH SYSTEM(for 3SZ-VE)  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.



PROCEDURE

Hide 1.FILL RESERVOIR WITH BRAKE FLUID

Hide 2.BLEED CLUTCH LINE

HINT:

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.


a.
C248995C03
2.448,0.448 2.813,0.448 true 2.365,0.563 2.729,0.927 true 2.865,0.365 3.063,0.531 0.198,0.167 10 *1 2.76,0.854 2.958,1.021 0.198,0.167 10 *2
*1 Release Cylinder Bleeder Plug Cap
*2 Release Cylinder Bleeder Plug


Remove the release cylinder bleeder plug cap.


b.

Connect a vinyl tube to the release cylinder bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.


d.

When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.


e.

Repeat both of the previous 2 steps 6 times.


f.

Tighten the release cylinder bleeder plug.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)


g.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



h.

Install the release cylinder bleeder plug cap.


i.

Check that all the air has been bled from the clutch line.


Hide 3.INSPECT FOR BRAKE FLUID LEAK