12321D
1.INSTALL REAR ENGINE MOUNTING BRACKET
Install the rear engine mounting bracket with the 3 bolts.
12371
2.INSTALL REAR ENGINE MOUNTING INSULATOR
Install the rear engine mounting insulator with the 2 bolts.
33823
3.INSTALL TRANSMISSION CONTROL CABLE BRACKET
Install the transmission control cable bracket with the 2 bolts.
33030
4.INSTALL MANUAL TRANSMISSION ASSEMBLY
| *1 | Wire Harness Clamp Bracket |
| *2 | Clutch Housing Under Cover |
Install the manual transmission assembly and the clutch housing under cover, 2 wire harness clamp brackets with the 9 bolts.
Bolt length:
Bolt A: 57mm (2.244 in.)
Bolt B: 50 mm (1.969 in.)
Bolt C: 40 mm (1.575 in.)
Bolt D: 95 mm (3.740 in.)
Install the manual transmission assembly after fully aligning the straight pin positions.
Tighten the 4 C bolts after tightening bolts A, B and D.
28100
5.INSTALL STARTER ASSEMBLY
12281A
6.REMOVE ENGINE HANGER
7.INSTALL ENGINE AND TRANSMISSION ASSEMBLY (for 3SZ-VE)
8.INSTALL ENGINE AND TRANSMISSION ASSEMBLY (for K3-VE)