1.REMOVE REAR WHEEL
42403
2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
89546
3.SEPARATE REAR SPEED SENSOR LH (w/ ABS)
Remove the bolt and separate the rear speed sensor LH from the rear axle housing.
42340B
4.REMOVE REAR AXLE SHAFT ASSEMBLY LH
Remove the 4 nuts through the service hole.
Using SST, remove the rear axle shaft assembly LH.
Wipe off any oil from the shaft in order to prevent it from entering the bearing.
Be careful not to damage the oil seal with the spline at the end of the shaft.
w/o ABS
Remove the 4 setting bolts from the rear axle housing.
42311A
5.REMOVE REAR AXLE SHAFT OIL SEAL
Using SST, remove the oil seal.