Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM19Y0E _53 Suspension _002989 FRONT SUSPENSION _0015126 FRONT SHOCK ABSORBER A

FRONT SUSPENSION  FRONT SHOCK ABSORBER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

a.

Install 3 new nuts to the upper side of the front shock absorber with coil spring.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


b.

Install the 2 bolts and 2 new nuts to the lower side of the front shock absorber with coil spring.

Torque:
128 N*m (1300 kgf*cm, 94 ft.*lbf)

NOTICE:

Keep the bolts from rotating and turn the nuts.



c.

Fully tighten the front support to front shock absorber nut.

Torque:
47 N*m (480 kgf*cm, 35 ft.*lbf)


Hide 48684 2.INSTALL BEARING DUST COVER

Hide 89543 3.INSTALL FRONT SPEED SENSOR

a.

Connect the front speed sensor wire harness clamp to the shock absorber.


b.

Install the front speed sensor bracket with the bolt.

Torque:
7.4 N*m (75 kgf*cm, 65 in.*lbf)


Hide 47313A 4.INSTALL FRONT FLEXIBLE HOSE

a.

Install the front flexible hose with the bolt.

Torque:
17 N*m (175 kgf*cm, 13 ft.*lbf)


Hide 48820 5.INSTALL FRONT STABILIZER LINK ASSEMBLY

a.

Install the front stabilizer link assembly with a new nut.

Torque:
74 N*m (755 kgf*cm, 55 ft.*lbf)

HINT:

If the ball joint turns together with the nut, use a socket hexagon wrench 6 to hold the stud.



Hide 6.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT