Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015140 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 67918E 1.REMOVE REAR DOOR SCUFF PLATE LH

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL)

HINT:

Use the same procedure as for the RH side.


Hide 73570 4.SEPARATE REAR NO. 2 SEAT OUTER BELT ASSEMBLY

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL)

HINT:

Use the same procedure as for the RH side.


Hide 64740C 5.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL)

HINT:

Use the same procedure as for the RH side.


Hide 6.REMOVE REAR WHEEL

Hide 89546 7.REMOVE REAR SPEED SENSOR

a.
C248979

Disconnect the clamp from the body.


b.
C248980

Disconnect the speed sensor connector.


c.
C249630

Pull out the grommet from the body.


d.

Remove the bolt and separate the sensor bracket from the body.


e.

Disconnect the 2 clamps from the upper arm.


f.
C248981

Remove the bolt and separate the sensor bracket from the rear axle housing.


g.

Disconnect the 2 clamps from the rear axle housing.


h.

Remove the bolt and rear speed sensor.

NOTICE:
·

Keep the speed sensor tip and installation portion free of foreign matter.

·

Remove the speed sensor without turning it from its original installation angle.