Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › 2011.11–2015.08
RM19Y0E _56 Audio / Visual / Telematics _003000 AUDIO / VIDEO _0015166 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The stereo jack adapter assembly sends and external device sound signal to the stereo component tuner assembly through this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component tuner assembly or speakers.

WIRING DIAGRAM

E234130E02
5.375,5.385 6.958,6.042 1.583,0.656 10 STEREO COMPONENT TUNER ASSEMBLY 0.542,5.573 2.063,6.229 1.521,0.656 10 STEREO JACK ADAPTER ASSEMBLY 3.292,4.99 4.115,5.25 0.823,0.26 10 (Shielded) 5.719,4.875 6.188,5.042 0.469,0.167 10 AUXG 5.719,3.063 6.083,3.229 0.365,0.167 10 ALI 5.344,3.083 5.708,3.25 0.365,0.167 10 E5 5.344,3.688 5.708,3.854 0.365,0.167 10 E5 5.719,3.656 6.083,3.823 0.365,0.167 10 ARI 5.719,4.271 6.198,4.438 0.479,0.167 10 ASGN 1.177,4.896 1.604,5.063 0.427,0.167 10 AGND 1.292,3.094 1.615,3.26 0.323,0.167 10 ALO 1.271,3.677 1.615,3.844 0.344,0.167 10 ARO 1.167,4.281 1.604,4.448 0.438,0.167 10 ASGN 5.344,2.906 5.521,3.073 0.177,0.167 10 17 5.708,0.719 6.135,0.885 0.427,0.167 10 UDI+ 5.313,0.719 5.677,0.885 0.365,0.167 10 E53 5.406,0.552 5.583,0.719 0.177,0.167 10 3 5.719,1.313 6.156,1.479 0.438,0.167 10 UDI- 5.313,1.323 5.677,1.49 0.365,0.167 10 E53 5.396,1.146 5.573,1.313 0.177,0.167 10 2 1.167,0.719 1.594,0.885 0.427,0.167 10 UDO+ 1.729,0.646 1.906,0.813 0.177,0.167 10 3 1.167,1.333 1.604,1.5 0.438,0.167 10 UDO- 1.729,1.24 1.906,1.406 0.177,0.167 10 2 1.729,3.01 1.906,3.177 0.177,0.167 10 6 1.719,3.604 1.896,3.771 0.177,0.167 10 5 1.729,4.188 1.906,4.354 0.177,0.167 10 7 1.729,4.781 1.906,4.948 0.177,0.167 10 9 5.344,3.5 5.521,3.667 0.177,0.167 10 15 5.354,4.271 5.719,4.438 0.365,0.167 10 E5 5.344,4.083 5.521,4.25 0.177,0.167 10 18 5.344,4.875 5.708,5.042 0.365,0.167 10 E5 0.542,5.385 0.906,5.552 0.365,0.167 10 E52 5.344,4.688 5.521,4.854 0.177,0.167 10 16

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - STEREO JACK ADAPTER)
a.

Remove the stereo component tuner assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL


b.

Remove the stereo jack adapter assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO JACK ADAPTER ASSEMBLY>REMOVAL


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
E5-15 (ARI) - E52-5 (ARO) Always Below 1 Ω
E5-16 (AUXG) - E52-9 (AGND) Always Below 1 Ω
E5-17 (ALI) - E52-6 (ALO) Always Below 1 Ω
E5-18 (ASGN) - E52-7 (ASGN) Always Below 1 Ω
E53-2 (UD1-) - E52-2 (UDO-) Always Below 1 Ω
E53-3 (UD1+) - E52-3 (UDO+) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
E5-15 (ARI) - Body ground Always 10 kΩ or higher
E5-16 (AUXG) - Body ground Always 10 kΩ or higher
E5-17 (ALI) - Body ground Always 10 kΩ or higher
E5-18 (ASGN) - Body ground Always 10 kΩ or higher
E53-2 (UD1-) - Body ground Always 10 kΩ or higher
E53-3 (UD1+) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR