Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
1.INSTALL ANTENNA ASSEMBLY WITH HOLDER
Tie the string threaded into the pillar to a new antenna assembly with holder.
Thread the antenna cable through into the pillar using the string.
Install the antenna assembly with holder with the 2 screws.
Install the antenna assembly with holder with the 2 clamps.
Ensure that the cable of the antenna assembly with holder is installed along the reinforcement without looseness.
Remove the string.
Install the antenna plug to the antenna cord sub-assembly.
83100
2.INSTALL COMBINATION METER ASSEMBLY
55301
3.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY