55301
1.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
Engage the 5 guides and 8 claws to install the upper instrument panel sub-assembly.
Be careful not to damage the upper instrument panel sub-assembly.
Install the 4 screws <B>.
55521C
2.INSTALL STEREO OPENING COVER WITH BRACKET (w/o Radio Receiver)
Install the stereo opening cover with the 4 screws <A>.
86180
3.INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
55422C
4.INSTALL UPPER INSTRUMENT CENTER CLUSTER FINISH PANEL
Engage the 3 claws and 4 guides, and install the center upper instrument cluster finish panel.
55061
5.INSTALL NO. 1 CENTER INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
Engage the 2 claws and install the No. 1 center instrument panel register assembly.
55062
6.INSTALL NO. 2 CENTER INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
Use the same procedure as for the No. 1 center instrument panel register sub-assembly and the No. 2 center instrument panel register sub-assembly.
84330
7.INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
55412D
8.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL
Engage the 2 clips and 8 claws to install the center instrument cluster finish panel sub-assembly.
73970A
9.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Airbag System)
55501A
10.INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY (w/ Airbag System)
55411G
11.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
86160J
12.INSTALL PILLAR SPEAKER LH (w/ 6 Speaker)
86160P
13.INSTALL PILLAR SPEAKER RH (w/ 6 Speaker)
Use the same procedure as for the LH side.
62212
14.INSTALL FRONT PILLAR GARNISH LH (for 6 Speakers)
Engage the 3 clips and 2 guides to install the front pillar garnish.
62211
15.INSTALL FRONT PILLAR GARNISH RH (for 6 Speakers)
Use the same procedure as for the LH side.
62212
16.INSTALL FRONT PILLAR GARNISH LH (for 4 Speakers)
Use the same procedure as for the front pillar garnish LH (w/ 6 speaker) and the front pillar garnish LH (w/ 4 speaker).
62211
17.INSTALL FRONT PILLAR GARNISH RH (for 4 Speakers)
Use the same procedure as for the LH side.
62312B
18.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
19.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62112
20.INSTALL COWL SIDE TRIM BOARD LH
Install the cowl side trim board LH with the 2 clips.
62111C
21.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
67914B
22.INSTALL FRONT DOOR SCUFF PLATE LH
67913B
23.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
24.CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).