Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
55301
1.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
83100
2.REMOVE COMBINATION METER ASSEMBLY
3.REMOVE ANTENNA ASSEMBLY WITH HOLDER
| *1 | Antenna Cord Sub-assembly |
Remove the antenna plug form the antenna cord sub-assembly.
| *1 | String |
Tie a string to the end of the antenna assembly with holder.
Use a string which is longer than the antenna assembly with holder.
Release the antenna assembly with holder from the 2 clamps.
Remove the 2 screws and the antenna assembly with holder.
Leave the string threaded through into the pillar so that it can be used when a new antenna assembly with holder is installed.