All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabet code in the table below.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67914B
2.REMOVE FRONT DOOR SCUFF PLATE LH
67913B
3.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
62112
4.REMOVE COWL SIDE TRIM BOARD LH
Remove the 2 clips and cowl side trim board LH.
62111C
5.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
62312B
6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
7.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
62212
8.REMOVE FRONT PILLAR GARNISH LH (for 6 Speakers)
Disengage the 3 clips and 2 guides and remove the front pillar garnish LH.
62211
9.REMOVE FRONT PILLAR GARNISH RH (for 6 Speakers)
Use the same procedure as for the LH side.
62212
10.REMOVE FRONT PILLAR GARNISH LH (for 4 Speakers)
Use the same procedure as for the front pillar garnish LH (w/ 6 speakers) and the front pillar garnish LH (w/ 4 speakers).
62211
11.REMOVE FRONT PILLAR GARNISH RH (for 4 Speakers)
Use the same procedure as for the LH side.
86160P
12.REMOVE PILLAR SPEAKER RH (w/ 6 Speakers)
86160J
13.REMOVE PILLAR SPEAKER LH (w/ 6 Speakers)
Use the same procedure as for the LH side.
55411G
14.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
55501A
15.REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY (w/ Airbag System)
73970A
16.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Airbag System)
55412D
17.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
Disengage the 2 clips and 8 claws and remove the center instrument cluster finish panel sub-assembly.
84330
18.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
55061
19.REMOVE NO. 1 CENTER INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
Disengage the 2 claws and remove the No. 1 center instrument panel register sub-assembly.
55062
20.REMOVE NO. 2 CENTER INSTRUMENT PANEL REGISTER SUB-ASSEMBLY
Use the same procedure as for the No. 1 center instrument panel register sub-assembly and the No. 2 center instrument panel register sub-assembly.
55422C
21.REMOVE UPPER INSTRUMENT CENTER CLUSTER FINISH PANEL
Disengage the 3 claws and 4 guides, and remove the center upper instrument cluster finish panel.
86180
22.REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
55521C
23.REMOVE STEREO OPENING COVER WITH BRACKET (w/o Radio Receiver)
Remove the 4 screws <B> and stereo opening cover.
55301
24.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
Remove the 4 <B> screws.
Disengage the 8 claws and 5 guides, and remove the upper instrument panel sub-assembly.
Be careful not to damage the upper instrument panel sub-assembly when removing it.