Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM19Y0E _56 Audio / Visual / Telematics _003001 PARK ASSIST / MONITORING _0015174 TOYOTA PARKING ASSIST-SENSOR SYSTEM J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  Back Sonar Sensor Circuit  


DESCRIPTION

The No. 1 ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.

WIRING DIAGRAM

E238946
4.406,3.073 6.146,3.792 1.74,0.719 10 CLEARANCE WARNING ECU ASSEMBLY 1.156,1.313 3.125,2.24 1.969,0.927 10 NO. 1 ULTRASONIC SENSOR (Back Sonar Sensor RH) 1.156,3.01 3.385,3.802 2.229,0.792 10 NO. 1 ULTRASONIC SENSOR (Back Sonar Sensor LH) 4.417,2.906 4.896,3.167 0.479,0.26 10 J11 2.802,0.406 3.271,0.813 0.469,0.406 10 2 2.802,0.677 3.208,1.021 0.406,0.344 10 1 2.615,0.51 3.073,0.958 0.458,0.448 10 S 2.615,0.771 2.979,1.135 0.365,0.365 10 E 2.802,2.052 3.188,2.51 0.385,0.458 10 1 2.802,2.323 3.188,2.76 0.385,0.438 10 2 4.406,2.333 4.865,2.719 0.458,0.385 10 8 4.333,0.417 4.854,0.823 0.521,0.406 10 16 4.333,2.073 4.844,2.458 0.51,0.385 10 15 2.615,2.156 3.073,2.438 0.458,0.281 10 E 2.615,2.417 2.969,2.823 0.354,0.406 10 S 4.583,0.5 5.104,0.927 0.521,0.427 10 T2 4.583,2.146 5.135,2.479 0.552,0.333 10 TE 4.583,2.417 5.125,2.719 0.542,0.302 10 T1 1.156,1.146 1.656,1.5 0.5,0.354 10 Q2 1.156,2.833 1.656,3.177 0.5,0.344 10 Q1

CAUTION / NOTICE / HINT

HINT:

Inspection should be performed on the back sonar sensor circuit on the side where the clearance sonar is malfunctioning.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BACK SONAR SENSOR)
a.

Disconnect the J11 clearance warning ECU assembly connector.


b.

Disconnect the Q2*1 or Q1*2 No. 1 ultrasonic sensor connector.

*1: Back sonar sensor RH

*2: Back sonar sensor LH



c.

Measure the resistance according to the value(s) in the table below.

Standard resistance (Check for Open) (for RH):
Tester Connection Condition Specified Condition
J11-16 (T2) - Q2-2 (S) Always Below 1 Ω
J11-15 (TE) - Q2-1 (E) Always Below 1 Ω


Standard resistance (Check for Open) (for LH):
Tester Connection Condition Specified Condition
J11-15 (TE) - Q1-1 (E) Always Below 1 Ω
J11-8 (T1) - Q1-2 (S) Always Below 1 Ω


Standard resistance (Check for Short) (for RH):
Tester Connection Condition Specified Condition
J11-16 (T2) - Body ground Always 10 kΩ or higher
J11-15 (TE) - Body ground Always 10 kΩ or higher


Standard resistance (Check for Short) (for LH):
Tester Connection Condition Specified Condition
J11-15 (TE) - Body ground Always 10 kΩ or higher
J11-8 (T1) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

2.INSPECT NO. 1 ULTRASONIC SENSOR (BACK SONAR SENSOR RH OR LH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT NO. 1 ULTRASONIC SENSOR (BACK SONAR SENSOR RH OR LH)
a.

Replace the No. 1 ultrasonic sensor with a new one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR>REMOVAL

Result:
Proceed to
NEXT




NEXT

3.CHECK BACK SONAR SYSTEM
3.CHECK BACK SONAR SYSTEM
a.

Check the operation of the TOYOTA parking assist-sensor system.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>OPERATION CHECK

Result:
Result Proceed to
TOYOTA parking assist-sensor system malfunction A
TOYOTA parking assist-sensor system normal operation B




A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

B

END