Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
RM19Y0E _57 Power Source / Network _003004 NETWORKING _0015181 CAN COMMUNICATION SYSTEM L

NETWORKING  CAN COMMUNICATION SYSTEM  PRECAUTION  


CAN COMMUNICATION SYSTEM TROUBLESHOOTING


a.

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (Click here Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).



BUS LINE REPAIR


a.
F045104

After repairing a bus line with solder, wrap the repaired part with electrical tape.

NOTICE:
·

The CANL bus line and CANH bus line must be installed together at all times.

·

When installing, make sure that these lines are twisted, because CAN bus lines are likely to be influenced by electrical noise if the bus lines are not twisted.

·

Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connector.

·

When repairing the CAN bus lines, do not change the length of the lines. (Make sure that the length of the CANH bus line and CANL bus line are the same.)




b.
E134624C04
1.708,0.604 1.854,0.604 1.854,0.604 2.052,1.031 false 1.5,0.51 2.24,1.021 0.74,0.51 10 *a
*1 Bypass Wire


Do not use bypass wiring between connectors.

NOTICE:
·

The ability of the twisted bus lines to resist interference will be lost if bypass wiring is used.

·

Do not use a twisted pair of wires for bypass wiring.





CONNECTOR HANDLING


a.
E120443C04
1.802,1.219 1.281,1.594 1.281,1.594 1.542,1.542 true 1.073,1.521 1.448,1.813 0.375,0.292 10 *a
*a Tester Probe


When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.


b.
E120444C04
1.458,0.917 1.875,0.594 1.875,0.594 1.531,1.292 true 1.875,0.594 1.958,0.594 false 1.979,0.51 2.729,1.094 0.75,0.583 10 *a
*a Service Wire


Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.