Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
69720B
1.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Install the front door lock remote control cable assembly.
69760C
2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
Install the front door inside locking cable assembly.
69712A
3.INSTALL FRONT DOOR LOCK REMOTE CONTROL LINK
Install the front door lock remote control link.
69312
4.INSTALL FRONT DOOR LOCK OPEN ROD
Install the front door lock open rod.
69320
5.INSTALL FRONT DOOR LOCK ASSEMBLY
If reusing the front door lock assembly that has been removed, replace the door lock wiring harness seal with a new one.
Make sure that no grease or dirt adheres to the door lock wire harness seal surface.
Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the front door lock assembly.
Apply MP grease to the sliding parts and rotating areas of the front door lock assembly.
Using a "TORX" socket wrench T30, install the front door lock assembly with the 3 screws.
Connect the connector.
Connect the front door lock open rod as shown in the illustration.
Connect the front door lock remote control link as shown in the illustration.
67404F
6.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
68151E
7.INSTALL FRONT DOOR GLASS RUN
68102
8.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
9.INSTALL FRONT DOOR SERVICE HOLE COVER
69206B
10.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
86160
11.INSTALL FRONT DOOR SPEAKER ASSEMBLY
67602
12.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
74640C
13.INSTALL DOOR ASSIST GRIP ASSEMBLY
67492A
14.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH