Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015192 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B2795/21  Unmatched Key Code  


DESCRIPTION

This DTC is stored when key ID codes (serial number) are mismatched during the transponder communication is inserted into the ignition key cylinder.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2795/21 Unmatched Key Code When key ID codes (serial number) are mismatched during the transponder communication is inserted into the ignition key cylinder (1 trip detection logic*).
·

Key

·

Transponder key ECU assembly


Insert the key into the ignition key cylinder.

*: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation When Malfunction Detected
Engine cannot be started -

Related Data List and Active Test
DTC Code Data List and Active Test
B2795/21 -

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the key or transponder key ECU assembly, refer to the Service Bulletin.

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Clear DTCs
50002 103
Result:
Proceed to
NEXT




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Trouble Codes
50001 103
HINT:

If DTC B2795/21 is output, check for DTCs with the next key after clearing the DTCs.


OK:

DTC B2795/21 is not output.


Result:
Result Proceed to
OK A
NG (all keys) B
NG (any key) C




A

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C

3.CHECK IGNITION SWITCH (OPERATION)
3.CHECK IGNITION SWITCH (OPERATION)
a.

Check that the ignition switch can be turned to ON using the key for the DTC was stored.

OK:

Ignition switch can be turned to ON using the key for the DTC was stored.


Result:
Proceed to
OK
NG




OK

4.KEY REGISTRATION

NG

REPLACE KEY THAT CANNOT START ENGINE

4.KEY REGISTRATION
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Clear DTCs
50002 103

b.

Reregister the key code with the transponder key ECU assembly (refer to the Service Bulletin).

OK:

Registration procedure can be completed.


Result:
Proceed to
OK
NG




OK

END (KEY CODE IS NOT REGISTERD NORMALLY)

NG

REPLACE KEY THAT CANNOT START ENGINE