Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015192 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B2792/13  Antenna Coil Open / Short  B2796/12  Transponder / Antenna Coil Malfunction  


DESCRIPTION

The antenna coil receives key code signals from the transponder chip in the key grip. The antenna coil is built into the transponder key coil, which amplifies the key code signals and outputs the signals to the transponder key ECU assembly.

DTC B2792/13 is stored when there is an open in the antenna coil.

DTC B2796/12 is stored when after the immobiliser coil is energized, no response is received from the key.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2792/13 Antenna Coil Open / Short The antenna coil built into the transponder key coil is open (determined by communication with transponder key ECU assembly) (1 trip detection logic*).
·

Terminal COL+ or COL- is open.

·

The antenna coil built into the transponder key coil is open.


·

Wire harness or connector

·

Transponder key coil

·

Transponder key ECU assembly


DTC Output Confirmation Operation

·

Insert the key into the ignition key cylinder.



B2796/12 Transponder / Antenna Coil Malfunction After the immobiliser coil is energized, no response is received from the key
·

Wire harness or connector

·

Transponder key coil

·

Transponder key ECU assembly


DTC Output Confirmation Operation

·

Insert the key into the ignition key cylinder.




*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -

Related Data List and Active Test
DTC Code Data List and Active Test
B2792/13 -
B2796/12 -

WIRING DIAGRAM

B298730E02
0.719,2.375 3.406,2.792 2.688,0.417 10 TRANSPONDER KEY AMPLIFIER 0.667,1.167 1.74,1.76 1.073,0.594 10 Antenna Coil 4.323,2.354 7.083,2.792 2.76,0.438 10 TRANSPONDER KEY ECU ASSEMBLY 5.167,1.708 5.927,2.115 0.76,0.406 10 COL- 5.167,0.635 5.885,1.104 0.719,0.469 10 COL+ 4.917,1.604 5.427,2.042 0.51,0.438 10 16 4.958,0.552 5.448,1.073 0.49,0.521 10 5 3.083,0.542 3.49,0.927 0.406,0.385 10 1 3.083,1.604 3.542,2.052 0.458,0.448 10 7 4.323,2.198 4.875,2.531 0.552,0.333 10 E58 0.729,2.219 1.24,2.531 0.51,0.313 10 E56 2.625,1.604 3.354,2.031 0.729,0.427 10 COL- 2.615,0.542 3.208,0.885 0.594,0.344 10 COL+

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the transponder key ECU assembly, refer to the Service Bulletin.

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Clear DTCs
50002 103
Result:
Proceed to
NEXT




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

OK:

DTC B2792/13 is not output.


Body Electrical > Immobiliser > Trouble Codes
50001 103
Result:
Proceed to
OK
NG




OK

NG

3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY COIL)
3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY COIL)
a.

Disconnect the E58 transponder key ECU assembly connector.


b.

Disconnect the E56 transponder key coil connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
E58-5 (COL+) - E56-1 (COL+) Always Below 1 Ω
E58-16 (COL-) - E56-7 (COL-) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
E58-5 (COL+) - Body ground Always 10 kΩ or higher
E58-16 (COL-) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

4.REPLACE TRANSPONDER KEY COIL

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TRANSPONDER KEY COIL
a.

Temporarily replace the transponder key coil with a new or normally functioning one.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL

Result:
Proceed to
NEXT




NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Trouble Codes
50001 103
OK:

DTC B2792/13 is not output.


Result:
Proceed to
OK
NG




OK

END (TRANSPONDER KEY COIL WAS DEFECTIVE)

NG

REPLACE TRANSPONDER KEY ECU ASSEMBLY