1.REMOVE REAR DOOR SCUFF PLATE LH
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL)
Use the same procedure for the RH side.
2.REMOVE BACK DOOR SCUFF PLATE
3.SEPARATE REAR NO. 2 OUTER SEAT BELT ASSEMBLY
Remove the bolt and separate the floor anchor plate of the rear No. 2 outer seat belt assembly.
4.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL)
Use the same procedure for the RH side.
5.REMOVE THEFT WARNING ECU ASSEMBLY
Disconnect the connector.
Remove the 3 nuts and theft warning ECU assembly.