Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  0043  Lost Proper EEPROM Communication with MET itself  


DESCRIPTION

The combination meter assembly cannot receive the ECU information signals from the ECM or TCM.

DTC No. Detection Item DTC Detection Condition Trouble Area
0043 Lost Proper EEPROM Communication with MET itself The combination meter assembly does not control EEPROM module.
·

CAN communication system

·

ECM

·

TCM

·

Combination meter assembly



PROCEDURE

1.CONFIRM DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check DTCs.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

OK:

CAN communication system DTC is not output.


Result:
Proceed to
OK
NG




OK

2.REPLACE ECM

NG

2.REPLACE ECM
a.

Temporarily replace the ECM with a new or normally functioning one.


Result:
Proceed to
NEXT




NEXT

3.CONFIRM DTC OUTPUT
3.CONFIRM DTC OUTPUT
a.

Check DTCs.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR

OK:

DTC 0043 is not output.


Result:
Result Proceed to
NG A
OK B




A

4.REPLACE TCM

B

END (ECM WAS DEFECTIVE)

4.REPLACE TCM
a.

Temporarily replace the TCM with a new or normally functioning one.

Click hereDrivetrain>A4Q AUTOMATIC TRANSMISSION / TRANSAXLE>TCM>REMOVAL

Result:
Proceed to
NEXT




NEXT

5.CONFIRM DTC OUTPUT
5.CONFIRM DTC OUTPUT
a.

Check DTCs.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR

OK:

DTC 0043 is not output.


Result:
Result Proceed to
NG A
OK B




A

REPLACE COMBINATION METER ASSEMBLY

B

END (TCM WAS DEFECTIVE)