Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015208 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL STEERING PAD ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Support the steering pad assembly with one hand.


d.
B296829C01
2.083,3.021 2.438,2.646 true 1.979,3.031 2.167,3.188 0.188,0.156 10 *1
*1 Locking Button


Connect the horn wire harness connector to the steering pad contact plate.


e.

Connect the airbag connector to the steering pad assembly.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



f.

Push in the locking button to lock the airbag connector.


g.
B296830C01
0.438,2.302 0.729,2.521 true 1.844,2.302 1.625,2.542 true 3.104,2.333 2.802,2.604 true 0.271,2.198 0.458,2.354 0.188,0.156 10 *1 1.865,2.24 2.052,2.396 0.188,0.156 10 *1 3.115,2.219 3.302,2.375 0.188,0.156 10 *1
*1 Spring


Push in the steering pad assembly and attach the 3 springs to install it.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 3.INSPECT STEERING PAD ASSEMBLY

a.

With the steering pad assembly installed to the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad assembly with a new one:

Cuts, minute cracks or marked discoloration on the steering pad assembly top surface or in the grooved portion.


b.

Make sure that the horn sounds.

If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).