Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015210 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for RHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55501A 3.REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY

Hide 73970A 4.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.
B296836C01
0.75,2.406 1.104,2.188 false 2.104,2.76 2.677,2.927 false 1.104,2.083 1.354,2.292 0.25,0.208 10 *1 2.708,2.854 2.938,3.073 0.229,0.219 10 *2
*1 Lock Slider
*2 Airbag Connector (Yellow Colored)


Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored).

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Remove the 2 bolts.


c.
B296837

Detach the 13 claws and remove the instrument panel passenger airbag assembly.

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.