Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015211 CENTER AIRBAG SENSOR ASSEMBLY G

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89170A 1.CHECK CENTER AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

a.

Perform a diagnostic system check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


Hide 89170A 2.CHECK CENTER AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)


b.

With the center airbag sensor removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the center airbag sensor with a new one:

·

Cuts, minute cracks or marked discoloration on the center airbag sensor assembly.

·

Deformation of the center airbag sensor assembly.

·

Dents in the center airbag sensor assembly.

·

Chips in the center airbag sensor assembly.

·

Cracks or other damage to the connector.

·

Peeling of the label.


OK:

No defects are found.


HINT:

If any defects are found, replace the center airbag sensor assembly with a new one.


CAUTION:

For removal and installation of the center airbag sensor assembly, be sure to follow the correct procedure.



Hide 89170A 3.CHECK CENTER AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag has Deployed)

a.

Replace the center airbag sensor assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL).

HINT:

The center airbag sensor assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.


CAUTION:

For removal and installation of the center airbag sensor assembly, be sure to follow the correct procedure.