Wear protective gloves. Sharp surfaces on the front seat frame assembly with adjuster could cause injuries to your hands.
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
72525A
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE
| *1 | Protective Tape |
| *2 | Snap Ring |
Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the reclining adjuster release handle.
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Belt Warning System)
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)
71811D
4.REMOVE FRONT SEAT CUSHION SHIELD
Remove the 2 screws and the front seat cushion shield.
71931
5.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
| *1 | Rubber Band |
Remove the 2 rubber bands from the front seat frame assembly with adjuster, and then turn the separate type front seat back cover over.
Detach the hook.
Remove the 3 hog rings.
Disengage the 2 claws and remove the front seat headrest support assembly.
71931
6.REMOVE FRONT SEAT HEADREST SUPPORT
Disengage the 2 claws and remove the front seat headrest support.
71073S
7.REMOVE SEPARATE TYPE FRONT SEAT BACK COVER
Remove the 3 hog rings and the separate type front seat back cover from the separate type front seat back pad.
71551S
8.REMOVE SEPARATE TYPE FRONT SEAT BACK PAD
Remove the separate type front seat back pad from the front seat frame assembly with adjuster.
71571
9.REMOVE FRONT SEAT BACK SILENCER PAD
Remove the front seat back silencer pad from separate type front seat back pad.
72137B
10.REMOVE SEAT TRACK COVER
Disengage the 8 claws and remove the 2 seat track covers.
71537C
11.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR
Disengage the 8 claws and remove the 4 front seat cushion edge protectors.
72991
12.REMOVE FRONT SEAT CUSHION COVER RH
Disengage the 2 claws and remove the front seat cushion cover RH.
72992
13.REMOVE FRONT SEAT CUSHION COVER LH
Use the same procedure as for the RH side.
72211
14.REMOVE SEAT TRACK ADJUSTING HANDLE
| *1 | Spring |
Lift the 2 springs using a screwdriver.
Pull the seat track adjusting handle in the direction indicated by the arrow in the illustration to remove it.
72110A
15.REMOVE FRONT SEAT OUTER TRACK ASSEMBLY
Remove the 2 bolts and the front seat outer track assembly.
72130A
16.REMOVE FRONT SEAT INNER TRACK ASSEMBLY
Use the same procedure as for the front seat outer track assembly.
71071S
17.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 clips.
Detach the 4 hooks.
Remove the 3 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.
71511S
18.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD
Remove the separate type front seat cushion pad from the front seat frame assembly with adjuster.
71521A
19.REMOVE FRONT SEAT CUSHION SILENCER PAD
Remove the front seat cushion silencer pad from the separate type front seat cushion pad.
71831D
20.REMOVE FRONT SEAT HINGE COVER
Disengage the 2 claws and guide and remove the front seat hinge cover.
71329A
21.REMOVE FRONT SEAT CUSHION REINFORCE SUB-ASSEMBLY
Remove the bolt, nut and front seat cushion reinforce sub-assembly.