Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0015219 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 73210 1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY (w/o pretensioner)

a.

Engage the 2 guides and temporarily install the front seat outer belt assembly with the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


b.

Install the floor anchor plate with the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


c.

Install the shoulder anchor with the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


d.

Check that the ELR locks.

NOTICE:

The check should be performed with the front seat outer belt installed.


i.

With the belt installed, check that the belt locks when it is pulled out quickly.

If the operation is not as specified, replace the front seat outer belt assembly.



Hide 73210 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY (w/ Pretensioner)

a.

Engage the 2 guides and temporarily install the front seat outer belt assembly with the screw.


b.

Install the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


c.
B329912C02
0.677,1.313 0.979,1.469 true 1.01,1.417 1.406,1.802 0.396,0.385 10 *1
*1 Locking Button


Connect the pretensioner connector and lock the locking button as shown in the illustration.


d.

Install the floor anchor plate with the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


e.

Install the shoulder anchor with the bolt.

Torque:
41 N*m (413 kgf*cm, 30 ft.*lbf)


f.
B293283

Engage the 2 claws and install the shoulder belt anchor cover.


g.

Check that the ELR locks.

NOTICE:
·

The check should be performed with the front seat outer belt installed.

·

Do not allow the anchor part of the front seat outer belt and the protruding parts of the floor panel to overlap.



i.

With the belt installed, check that the belt locks when it is pulled out quickly.

If the operation is not as specified, replace the front seat outer belt assembly.



Hide 73237A 3.INSTALL SHOULDER BELT ANCHOR COVER (w/o Pretensioner)

a.
B152636

Engage the 2 claws and install the shoulder belt anchor cover.


Hide 62413A 4.INSTALL CENTER PILLAR LOWER GARNISH

Hide 67917C 5.INSTALL REAR DOOR SCUFF PLATE

Hide 67913B 6.INSTALL FRONT DOOR SCUFF PLATE