Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0015219 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Be sure to read Precaution thoroughly before servicing. (Click here Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE

Hide 67917C 4.REMOVE REAR DOOR SCUFF PLATE

Hide 62413A 5.REMOVE CENTER PILLAR LOWER GARNISH

Hide 73237A 6.REMOVE SHOULDER BELT ANCHOR COVER (w/o Pretensioner)

a.
B152635C03
2.167,1.458 2.813,1.063 true 2.875,0.958 3.26,1.365 0.385,0.406 10 *1
*1 Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the shoulder belt anchor cover.


Hide 73210 7.REMOVE FRONT SEAT OUTER BELT ASSEMBLY (w/o Pretensioner)

a.
B152637

Loosen the bolt and disconnect the shoulder anchor.


b.
B157631

Loosen the bolt and disconnect the floor anchor plate.


c.
B296012

Loosen the bolt and disengage the 2 guides to remove the front seat outer belt assembly.


Hide 73210 8.REMOVE FRONT SEAT OUTER BELT ASSEMBLY (w/ Pretensioner)

a.
B298801C01
2.24,1.135 2.708,0.896 true 2.729,0.802 3.125,1.135 0.396,0.333 10 *1
*1 Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and pull up the shoulder belt anchor cover.


b.
B298802

Loosen the bolt and disconnect the shoulder anchor.


c.
B157631

Loosen the bolt and disconnect the floor anchor plate.


d.
B329911C01
0.896,1.167 1.188,1.365 true 1.208,1.302 1.625,1.688 0.417,0.385 10 *1
*1 Locking Button


Pull the locking button to release the connector lock.


e.

Disconnect the pretensioner connector from the retractor.

NOTICE:

When handling the pretensioner connector, take care not to damage the pretensioner wire harness.



f.
B298797

Remove the screw and bolt.


g.

Disengage the 2 guides to remove the front seat outer belt assembly.