Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(for 3SZ-VE) › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015232 CONDENSER(for 3SZ-VE) A

HEATING / AIR CONDITIONING  CONDENSER(for 3SZ-VE)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicle.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.

Engage the 2 guides and install the cooler condenser assembly into the vehicle.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when installing the condenser assembly.


HINT:

If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.


Capacity:

Add 40 cc (1.35 fl. oz.)


Compressor oil:

ND-OIL8 or equivalent.



b.

Install the 2 condenser brackets with the 2 bolts.


Hide 88716A 2.CONNECT LIQUID TUBE SUB-ASSEMBLY

a.

Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL8 or equivalent



c.

Install the O-ring onto the liquid tube.


d.

Install the liquid tube onto the cooler condenser assembly with the bolt.

Torque:
7.9 N*m (81 kgf*cm, 70 in.*lbf)


Hide 88711 3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL8 or equivalent



c.

Install the O-ring onto the No. 1 cooler refrigerant discharge hose.


d.

Install the discharge hose onto the cooler condenser assembly with the bolt.

Torque:
7.9 N*m (81 kgf*cm, 70 in.*lbf)


Hide 53208A 4.INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY

a.

Install the hood lock support sub-assembly with the 2 bolts.


Hide 88561K 5.INSTALL NO. 2 AIR INLET GRILLE

a.

Engage the claw to install the No. 2 air inlet grille.


b.

Install the 2 clips.


Hide 88561J 6.INSTALL NO. 1 AIR INLET GRILLE

a.

Engage the claw to install the No. 1 air inlet grille.


b.

Install the 2 clips.


c.

Engage the harness clamp.


Hide 88561D 7.INSTALL NO. 3 AIR INLET GRILLE

a.

Install the No. 3 air inlet grille with the 3 clips.


Hide 86520 10.INSTALL LOW PITCHED HORN ASSEMBLY

Hide 52119A 12.INSTALL FRONT BUMPER COVER

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)

Hide 15.WARM UP ENGINE