Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(for K3-VE) › 2011.11–2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015233 CONDENSER(for K3-VE) A

HEATING / AIR CONDITIONING  CONDENSER(for K3-VE)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicle.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 52119A 4.REMOVE FRONT BUMPER COVER

Hide 86520 6.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 7.REMOVE NO. 1 HOOD LOCK CONTROL CABLE COVER

Hide 88561J 10.REMOVE NO. 1 AIR INLET GRILLE

a.
E231794

Disengage the harness clamp.


b.
E231798

Remove the 4 clips.


c.

Disengage the claw and remove the No. 1 air inlet grille.


Hide 53208A 12.REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY

Hide 88711 13.SEPARATE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E231782

Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.


b.

Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 88716A 14.SEPARATE LIQUID TUBE SUB-ASSEMBLY

a.
E231783

Remove the bolt and disconnect the liquid tube sub-assembly from the cooler condenser assembly.


b.

Remove the O-ring from the liquid tube sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 88460 15.REMOVE COOLER CONDENSER ASSEMBLY

a.

Remove the 2 bolts to remove the 2 condenser brackets.


b.
E231845

Disengage the 2 claws and 2 guides and remove the cooler condenser assembly as shown indicated by the arrow in the illustration from the vehicle.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when removing the cooler condenser.