87030A
1.TEMPORARILY TIGHTEN REAR COOLING UNIT ASSEMBLY
Remove the attached vinyl tape from the disconnected parts of the tube and the pipe.
Sufficiently apply compressor oil (ND-OIL 8) to the 2 new O-rings and the fitting surfaces of the tube and the pipe.
ND-OIL 8 or equivalent
Install the O-rings to the tube and the pipe.
Fit the connections with the tube and the pipe and temporarily set the rear cooling unit assembly.
Temporarily tighten the rear cooling unit assembly with the bolt as shown in the illustration.
87030A
2.INSTALL REAR COOLING UNIT ASSEMBLY
Install the rear cooling unit assembly with the 5 bolts.
Tighten the bolts in the order indicated in the illustration.
Attach the clamp and install the wire harness.
88726C
3.INSTALL C COOLER REFRIGERANT LIQUID PIPE
Install the C cooler refrigerant liquid pipe with the union nut.
88737A
4.INSTALL COOL BOX SUCTION TUBE
Install the cool box suction tube with the union nut.
Install the new piping insulator.
Connect the 2 drain hoses.
63310
5.INSTALL ROOF HEADLINING ASSEMBLY
Refer to the instruction for installation of the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
6.CHARGE REFRIGERANT
7.WARM UP ENGINE
8.INSPECT LEAKAGE OF REFRIGERANT