1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
88570F
2.REMOVE AIR OUTLET GRILLE ASSEMBLY
88611A
3.REMOVE COOLER CONTROL SWITCH KNOB
Remove the cooler control switch knob.
84732H
4.REMOVE HEATER BLOWER SWITCH
Remove the 2 screws and heater blower switch.