Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015273 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  INSTALLATION  


PROCEDURE

Hide 85176R 1.INSTALL REAR WIPER LINK CAP

a.
E231724C02
3.188,3.313 3.323,3.313 false
V100145

MP Grease


Apply MP grease to the entire surface of the rear wiper link cap lip.

HINT:

Make sure that the hole does not get clogged with MP grease and the grooves on the lip are filled with MP grease.



b.
E231725C02
1.479,0.354 3.01,0.354 true 3.01,0.26 3.406,0.604 0.396,0.344 10 *1
*1 Mark


Install the rear wiper link cap with the mark directed up.


Hide 85131 2.INSTALL REAR WIPER MOTOR COVER

a.

Engage the 2 claws to install the rear wiper motor cover.


Hide 85110R 3.INSTALL REAR WIPER MOTOR ASSEMBLY

a.
E236679N01
3.052,0.698 3.385,1.021 0.333,0.323 10 1 0.563,0.74 0.927,1.073 0.365,0.333 10 2 1.729,1.719 2.125,2.094 0.396,0.375 10 3

Install the rear wiper motor with the 3 bolts in the order as shown in the illustration.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


b.

Connect the connector.


Hide 64780A 4.INSTALL BACK DOOR TRIM PANEL ASSEMBLY

Hide 85241A 5.INSTALL REAR WIPER ARM AND BLADE

a.
E231728C02
1.5,1.396 0.521,1.396 true 0.542,2.677 0.938,3.156 true 1.906,3.344 2.74,3.271 true 0.385,2.573 0.813,2.927 0.427,0.354 10 *1 0.354,1.333 0.719,1.677 0.365,0.344 10 *a 2.823,3.229 3.26,3.583 0.438,0.354 10 *b
*1 Wire Brush
*a Wiper Arm Serration
*b Wire Pivot Serration


Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).


b.

Clean the wiper pivot serrations with a wire brush.


c.

Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

HINT:

Temporarily connect the cable to the negative battery terminal when checking the operation.



d.
E231704C04
0.365,2.365 1.094,2.948 true 0.188,2.25 0.542,2.563 0.354,0.313 10 *a
*a Blade Position on Ceramic Line


Install the rear wiper arm and blade with the nut to the position as shown in the illustration.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

Hold the arm hinge by hand while tightening the nut.