Use these procedures to troubleshoot the anti-lock brake system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the trouble.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Measure the voltage of the battery.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check and record output DTCs and the freeze frame data.
Clear the DTCs and freeze frame data.
Reconfirm the DTCs.
Reconfirm the DTCs based on the recorded output DTCs and freeze frame data.
| Result | Proceed to |
|---|---|
| DTC output. | A |
| DTC not output (Problem symptom does not occur). | B |
| DTC not output (Problem symptom occurs). | C |
A
B
C
Proceed to Diagnostic Trouble Code Chart.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT