| ABS and/or EBD does not operate
|
Check for DTCs again and make sure that normal system code is output
|
|
| IG power source circuit
|
|
| Front speed sensor circuit
|
|
| Rear speed sensor circuit
|
|
| Check brake actuator assembly using intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leakage.
|
|
| If symptoms still occur even after above circuits are inspected and found to be normal, replace skid control ECU (brake actuator assembly)
|
|
| ABS and/or EBD does not operate normally
|
Check for DTCs again and make sure that normal system code is output
|
|
| Front speed sensor circuit
|
|
| Rear speed sensor circuit
|
|
| Check brake actuator assembly using the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leakage.
|
|
| If symptoms still occur even after above circuits are inspected and found to be normal, replace skid control ECU (brake actuator assembly)
|
|
| ABS warning light abnormal (Remains on)
|
ABS warning light circuit
|
|
| Skid control ECU (Brake actuator assembly)
|
|
| ABS warning light abnormal (Does not come on)
|
ABS warning light circuit
|
|
| Skid control ECU (Brake actuator assembly)
|
|
| Brake warning light abnormal (Remains on)
|
Brake warning light circuit
|
|
| Skid control ECU (Brake actuator assembly)
|
|
| Brake warning light abnormal (Does not come on)
|
Brake warning light circuit
|
|
| Skid control ECU (Brake actuator assembly)
|
|
| DTC check cannot be performed
|
Check for DTCs again and make sure that normal system code is output
|
|
| ECUT terminal circuit
|
|
| If symptoms still occur even after above circuits are inspected and found to be normal, replace skid control ECU (brake actuator assembly)
|
|
| Sensor check cannot be performed
|
ECUT terminal circuit
|
|
| Skid control ECU (Brake actuator assembly)
|
|