Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
74640D
3.REMOVE REAR DOOR ASSIST GRIP ASSEMBLY
Remove the screw.
Disengage the 9 claws and remove the rear door assist grip assembly.
84810
4.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
67604
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Remove the 3 screws.
Disengage the 7 clips and remove the rear door trim board sub-assembly.
69206C
6.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
| *1 | Claw |
| *2 | Guide |
Disengage the claw.
Disengage the 2 guides and remove the rear door inside handle sub-assembly.
| *1 | Rear Door Lock Remote Control Cable Assembly |
| *2 | Rear Door Inside Locking Cable Assembly |
Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly.
86160B
7.REMOVE REAR DOOR SPEAKER
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER
|
Rear Door Service Hole Cover |
|
Butyl Tape |
Remove the rear door service hole cover.
Remove any remaining butyl tape from the door panel.
68152C
9.REMOVE REAR DOOR GLASS RUN
Remove the rear door glass run.
67408F
10.REMOVE REAR DOOR REAR LOWER WINDOW GUIDE SUB-ASSEMBLY
Remove the bolt and rear door rear lower window guide sub-assembly.
67486B
11.REMOVE REAR DOOR DIVISION BAR SEAL
Remove the 2 screws and rear door division bar seal.
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Provisionally install the power window regulator switch assembly.
Connect the cable to the negative battery terminal.
Move the rear door glass sub-assembly until the 2 bolts can be seen through the service holes.
Remove the 2 bolts and rear door glass sub-assembly.
Do not drop or damage the rear door glass sub-assembly when removing the bolts.
Disconnect the cable from the negative battery terminal.
Remove the power window regulator switch assembly.
68230C
13.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
69804
14.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
Disconnect the connector.
| *1 | Temporary Bolt |
Loosen the temporary bolt.
Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator sub-assembly may fall and cause damage.
Remove the 5 bolts.
Remove the temporary bolt and rear door window regulator sub-assembly.
15.REMOVE HOLE PLUG
Remove the hole plug.
16.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
| *1 | Control Rod |
Disconnect the control rod.
Remove the 2 bolts and rear door outside handle assembly.
Do not drop or damage the rear door outside handle assembly when removing the bolts.
69340
17.REMOVE REAR DOOR LOCK ASSEMBLY
68640A
18.REMOVE REAR DOOR CHECK ASSEMBLY
Remove the 3 bolts and rear door check assembly.
Do not drop or damage the rear door check assembly when removing the bolts.
Remove the rear door check assembly through the service hole.
67872
19.REMOVE REAR DOOR WEATHERSTRIP
Disengage the 17 clips and remove the rear door weatherstrip.