Wear protective gloves. Sharp surfaces on the front seat frame with adjuster assembly could cause injuries to your hands.
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
71956A
1.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
| *1 | Rubber Band |
Disconnect the 2 rubber bands from the front seat frame with adjuster assembly, and then turn the separate type front seat back cover over.
Open the fastener.
Remove the 2 hog rings.
Disengage the 2 claws to remove the front seat headrest support assembly.
71956A
2.REMOVE FRONT SEAT HEADREST SUPPORT
Disengage the 2 claws to remove the front seat headrest support.
71073S
3.REMOVE SEPARATE TYPE FRONT SEAT BACK COVER
Remove the 13 hog rings and separate type front seat back cover from the separate type front seat back pad.
71551S
4.REMOVE SEPARATE TYPE FRONT SEAT BACK PAD
Remove the separate type front seat back pad from the front seat frame with adjuster assembly.
71571
5.REMOVE FRONT SEAT BACK SILENCER PAD
Remove the front seat back silencer pad from the separate type front seat back pad.
72525A
6.REMOVE RECLINING ADJUSTER RELEASE HANDLE
| *1 | Protective Tape |
| *2 | Snap Ring |
Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the reclining adjuster release handle.
71811D
7.REMOVE FRONT SEAT CUSHION SHIELD
| *1 | Clip |
Remove the 2 screws.
Disengage the clip and guide to remove the front seat cushion shield.
73230
8.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)
73230
9.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Belt Warning System)
71071S
10.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
| *1 | Hook |
Detach the 4 hooks.
Remove the 2 clips.
Remove the 11 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
71511S
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD
Remove the separate type front seat cushion pad from the front seat frame with adjuster assembly.
71521A
12.REMOVE FRONT SEAT CUSHION SILENCER PAD
Remove the front seat cushion silencer pad from the separate type front seat cushion pad.
71831D
13.REMOVE FRONT SEAT HINGE COVER
Disengage the 2 claws and guide to remove the front seat hinge cover.
72991
14.REMOVE FRONT SEAT CUSHION COVER RH
Remove the screw.
Disengage the 2 claws to remove the front seat cushion cover RH.
72992
15.REMOVE FRONT SEAT CUSHION COVER LH
Use the same procedure as for the RH side.
72211B
16.REMOVE SEAT TRACK ADJUSTING HANDLE
| *1 | Spring |
Using a screwdriver, disengage the 2 springs.
Pull the seat track adjusting handle in the direction indicated by the arrow in the illustration to remove it.
71127A
17.REMOVE FRONT SEAT CUSHION COVER SET PLATE
Remove the screw and front seat cushion cover set plate.
Use the same procedure for both sides.
71110A
18.REMOVE FRONT SEAT CUSHION REINFORCE SUB-ASSEMBLY
Remove the bolt, nut and front seat cushion reinforce sub-assembly.
71121
19.REMOVE FRONT SEAT CUSHION BRACKET
Remove the 2 nuts and front seat cushion bracket.
20.REMOVE GROMMET
Disengage the 4 claws to remove the 2 grommets.
21.REMOVE SEAT BELT HANGER BRACKET (w/ Seat Belt Warning System)
Remove the screw and seat belt hanger bracket.
71139A
22.REMOVE FRONT SEAT NO. 2 LEG COVER
Remove the screw.
Disengage the claw to remove the front seat No. 2 leg cover.
72110A
23.REMOVE FRONT SEAT OUTER TRACK ASSEMBLY
Remove the 2 bolts and front seat outer track assembly.
72130A
24.REMOVE FRONT SEAT INNER TRACK ASSEMBLY
Use the same procedure as for the front seat outer track assembly.
71537C
25.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR
Disengage the 2 claws to remove the front seat cushion edge protector.
Use the same procedure for all the front seat cushion edge protectors.
72137B
26.REMOVE SEAT TRACK COVER
Disengage the 4 claws to remove the seat track cover.
Use the same procedure for the other seat track covers.