1.REMOVE ENGINE AND TRANSMISSION ASSEMBLY (for 3SZ-VE)
2.REMOVE ENGINE AND TRANSMISSION ASSEMBLY (for K3-VE)
12281A
3.REMOVE ENGINE HANGER
35103
4.REMOVE TRANSMISSION OIL LEVEL DIPSTICK SUB-ASSEMBLY
Remove the transmission oil level dipstick sub-assembly.
35013
5.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
| *1 | O-ring |
Remove the bolt and the transmission oil filler tube sub-assembly.
Remove the O-ring from the transmission oil filler tube sub-assembly.
32906
6.REMOVE OIL COOLER TUBE SUB-ASSEMBLY
28100
7.REMOVE STARTER ASSEMBLY
35000
8.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.
Tilt the automatic transmission assembly until the bolts can be seen by gradually lowering the transmission jack.
Do not tilt the automatic transmission assembly more than necessary.
| *1 | Wire Harness Clamp Bracket |
Remove the 9 bolts, 2 wire harness clamp brackets and automatic transmission assembly.
51022
9.REMOVE REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY
Remove the 3 bolts and rear engine support member sub-assembly.
84248A
10.REMOVE SWITCH HARNESS CLAMP
Disconnect the park/neutral position switch connector clamp.
Remove the 2 bolts and switch harness clamp.
32000
11.REMOVE TORQUE CONVERTER ASSEMBLY
Remove the torque converter assembly from the automatic transmission assembly.