Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR › 2014.04–2015.08
RM19Y0E _55 Steering _002999 STEERING GEAR / LINKAGE _0015165 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 44200 1.INSTALL POWER STEERING GEAR

a.

Align the matchmarks and connect the steering intermediate shaft.


b.

Install the power steering gear to the front suspension member with the 4 bolts.

Torque:
95 N*m (970 kgf*cm, 70 ft.*lbf)


c.

Tighten the steering intermediate shaft with a new bolt.

Torque:
41 N*m (418 kgf*cm, 30 ft.*lbf)


Hide 45047 2.CONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Install the tie rod end sub-assembly LH to the steering knuckle, and tighten it with a new nut.

Torque:
47 N*m (479 kgf*cm, 35 ft.*lbf)

NOTICE:

Be careful not to damage the ball joint dust cover.



Hide 45046 3.CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 45220 4.CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

a.

Align the matchmarks and connect the steering intermediate shaft assembly to the power steering gear assembly.


b.

Install the bolt.

Torque:
41 N*m (418 kgf*cm, 30 ft.*lbf)


Hide 5.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 6.INSTALL FRONT WHEELS

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 51443 8.INSTALL REAR ENGINE UNDER COVER (for Full Cover Type)

Hide 51441 9.INSTALL ENGINE UNDER COVER (for Full Cover Type)

Hide 51441D 10.INSTALL ENGINE UNDER COVER (for Half Cover Type)