23210P
1.INSTALL FUEL PUMP WITH MOTOR AND BRACKET ASSEMBLY
Install a new fuel pump bracket gasket onto the fuel pump with motor and bracket assembly.
| *a | Protrusion |
| *b | Hole |
| *c | Concave |
Align the protrusion of the fuel pump with motor and bracket assembly with the hole in the fuel pump bracket as illustrated.
Align the protrusion of the fuel pump bracket with the concave of the fuel tank assembly.
Tighten the 8 screws in the sequence shown in the illustration.
Attach the clamp onto the fuel tank assembly.
Connect the fuel pump connector.
77204A
2.CONNECT FUEL TANK RETURN TUBE SUB-ASSEMBLY
| *1 | Checker |
|
Push |
|
Pull out |
Align a new fuel tank return tube sub-assembly (fuel tube connector) with the fuel pump tube, then push in the fuel return tube sub-assembly until the retainer makes a click sound. Then, pull out the checker.
Check that there are no scratches or foreign matter around the connected parts of the fuel pump tube and fuel tank return tube sub-assembly (fuel tube connector) before performing this work.
After connecting the fuel tank return tube sub-assembly (fuel tube connector), check that the fuel pump tube and fuel tank return tube sub-assembly are securely connected by pulling them.
If connecting the tubes is too tight, apply a light coat of appropriate lubricant or gasoline to the tip of the fuel pump tube.
Attach the fuel tank return tube sub-assembly to the No. 1 fuel tube clamp.
77203A
3.CONNECT FUEL SUCTION TUBE SUB-ASSEMBLY
| *1 | Checker |
|
Push |
|
Pull out |
Align a new fuel suction tube sub-assembly (fuel tube connector) with the fuel pump tube, then push in the fuel suction tube until the retainer makes a click sound. Then, pull out the checker.
Check that there are no scratches or foreign matter around the connected parts of the fuel pump tube and fuel suction tube sub-assembly (fuel tube connector) before performing this work.
After connecting the fuel suction tube sub-assembly (fuel tube connector), check that the fuel pump tube and fuel suction tube sub-assembly are securely connected by pulling them.
If connecting the tubes is too tight, apply a light coat of appropriate lubricant or gasoline to the tip of the fuel pump tube.
Attach the fuel suction tube sub-assembly to the No. 1 fuel tube clamp.
77100
4.INSTALL FUEL TANK ASSEMBLY