77100
1.REMOVE FUEL TANK ASSEMBLY
77203A
2.DISCONNECT FUEL SUCTION TUBE SUB-ASSEMBLY
Detach the fuel suction tube sub-assembly from the No. 1 fuel tube clamp.
| *1 | Retainer |
| *2 | O-ring |
| *3 | Nylon Tube |
| *4 | Fuel Tube Connector |
| *5 | Fuel Pump Tube |
|
Pinch |
|
Pull out |
Pinch the retainer to unlock it as illustrated, then pull the fuel suction tube sub-assembly (fuel tube connector) out of the fuel pump tube.
Remove any dirt and foreign matter from the fuel tube connector.
Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel pump tube.
Perform this work by hand. Do not use any tools.
Do not forcibly bend, twist or turn the nylon tube.
Protect the disconnected parts by covering them with a plastic bag after disconnecting the fuel tube connector.
As some pressure remains in the fuel line, use a piece of cloth to prevent gasoline from splashing out.
If the fuel tube connector and fuel pump tube are stuck, pinch the fuel pump tube and push and pull the fuel tube connector to release them.
Remove the retainer from the fuel pump tube.
77204A
3.DISCONNECT FUEL TANK RETURN TUBE SUB-ASSEMBLY
Detach the fuel tank return tube sub-assembly from the No. 1 fuel tube clamp.
| *1 | Retainer |
| *2 | O-ring |
| *3 | Nylon Tube |
| *4 | Fuel Tube Connector |
| *5 | Fuel Pump Tube |
|
Pinch |
|
Pull out |
Pinch the retainer to unlock it as illustrated, then pull the fuel tank return tube sub-assembly (fuel tube connector) out of the fuel pump tube.
Remove any dirt and foreign matter from the fuel tube connector.
Do not allow any scratches or foreign matter on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel pump tube.
Perform this work by hand. Do not use any tools.
Do not forcibly bend, twist or turn the nylon tube.
Protect the disconnected parts by covering them with a plastic bag after disconnecting the fuel tube connector.
As some pressure remains in the fuel line, use a piece of cloth to prevent gasoline from splashing out.
If the fuel tube connector and fuel pump tube are stuck, pinch the fuel pump tube and push and pull the fuel tube connector to release them.
Remove the retainer from the fuel pump tube.
23221
4.REMOVE FUEL PUMP WITH MOTOR AND BRACKET ASSEMBLY
Disconnect the fuel pump connector.
Detach the clamp from the fuel tank assembly to remove the wire harness.
Remove the 8 screws to remove the fuel pump bracket.
Remove the fuel pump with motor and bracket assembly from the fuel tank assembly.
Do not damage the fuel pump filter.
Make sure that the fuel sender gauge arm does not bend.
Remove the fuel pump bracket gasket from the fuel pump with motor and bracket assembly.