Use the same procedure for both the RHD and LHD vehicles.
The procedure described below is for the RHD vehicles.
45254
1.INSTALL STEERING COLUMN HOLE SHIELD
Install the steering column hole shield to the steering column assembly.
Attach the steering column hole shield to the floor panel.
45250
2.INSTALL STEERING COLUMN ASSEMBLY
|
Bolt |
|
Nut |
Hold up the steering column assembly and install the steering column assembly to the instrument panel reinforcement assembly with the 2 nuts and 2 bolts.
Be careful not to damage the brake booster assembly by hitting with the steering main shaft.
Be careful not to damage the steering column hole shield.
Tighten the 2 nuts (lower side) first, and then tighten the 2 bolts (upper side).
Align the matchmarks and install the lower side of the steering column assembly onto the steering intermediate shaft assembly with a new bolt.
89650
3.INSTALL POWER STEERING ECU ASSEMBLY
89782
4.INSTALL TRANSPONDER KEY COIL (w/ Engine Immobiliser System)
5.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE
Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable to the steering column assembly.
Connect all the connectors to the combination switch assembly with spiral cable.
45286B
6.INSTALL UPPER STEERING COLUMN COVER
Engage the claw and install the upper steering column cover.
45287
7.INSTALL LOWER STEERING COLUMN COVER
Engage the 2 claws to install the lower steering column cover.
Install the 3 screws.
45100
8.INSTALL STEERING WHEEL SUB-ASSEMBLY