Wear protective gloves. Sharp surfaces on the front seat frame with adjuster assembly could cause injuries to your hands.
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
72525A
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE
| *1 | Protective Tape |
| *2 | Snap Ring |
Using a screwdriver with its tip wrapped in protective tape, pull out the snap ring and remove the reclining adjuster release handle.
71811D
2.REMOVE FRONT SEAT CUSHION SHIELD
Remove the 2 screws.
Disengage the clip and pull in the removal direction shown in the illustration to remove the front seat cushion shield.
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Driver Side)
73240
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Front Passenger Side)
71956A
5.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
| *1 | Rubber Band |
Disconnect the 2 rubber bands from the front seat frame with adjuster assembly, and then turn the separate type front seat back cover over.
Disengage the hook.
Remove the 2 hog rings.
Disengage the 2 claws to remove the front seat headrest support assembly.
71956A
6.REMOVE FRONT SEAT HEADREST SUPPORT
Disengage the 2 claws to remove the front seat headrest support.
71073S
7.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 13 hog rings and separate type front seatback cover from the separate type front seatback pad.
71551S
8.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the separate type front seatback pad from the front seat frame with adjuster assembly.
71571
9.REMOVE FRONT SEATBACK SILENCER PAD
Remove the front seatback silencer pad from the separate type front seatback pad.
71071S
10.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 clips.
Disengage the 4 hooks.
Remove the 11 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
71511S
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD
Remove the separate type front seat cushion pad from the front seat frame with adjuster assembly.
71521A
12.REMOVE FRONT SEAT CUSHION SILENCER PAD
Remove the front seat cushion silencer pad from the separate type front seat cushion pad.
89953A
13.REMOVE BELT WARNING OCCUPANT DETECTION SENSOR (for Front Passenger Side)
71831D
14.REMOVE FRONT SEAT HINGE COVER
Disengage the 2 claws and guide to remove the front seat hinge cover.
72991
15.REMOVE FRONT SEAT CUSHION COVER RH
Disengage the 2 claws to remove the front seat cushion cover RH.
72992
16.REMOVE FRONT SEAT CUSHION COVER LH
Use the same procedure as for the RH side.
72211B
17.REMOVE SEAT TRACK ADJUSTING HANDLE
| *1 | Spring |
Using a screwdriver, disengage the 2 springs.
Pull the seat track adjusting handle in the direction indicated by the arrow in the illustration to remove it.
71127A
18.REMOVE FR0NT SEAT CUSHION COVER SET PLATE
Use the same procedure for both sides.
Remove the screw and front seat cushion cover set plate.
19.REMOVE FRONT SEAT CUSHION REINFORCE SUB-ASSEMBLY
Remove the bolt and nut, and remove the front seat cushion reinforce sub-assembly.
71121
20.REMOVE FRONT SEAT CUSHION BRACKET
Remove the 2 nuts and front seat cushion bracket.
Disengage the 4 claws to remove the 2 grommets from the front seat cushion bracket.
21.REMOVE SEAT BELT HANGER BRACKET
Remove the screw and seat belt hanger bracket.
71139A
22.REMOVE FRONT SEAT LEG COVER
Remove the screw.
Disengage the claw to remove the front seat leg cover.
72110A
23.REMOVE FRONT SEAT OUTER TRACK ASSEMBLY
Remove the 2 bolts and front seat outer track assembly.
72130A
24.REMOVE FRONT SEAT INNER TRACK ASSEMBLY
Use the same procedure as for the front seat outer track assembly.
71537C
25.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR
Disengage the 8 claws to remove the 4 front seat cushion edge protectors.
72137B
26.REMOVE SEAT TRACK COVER
Disengage the 8 claws to remove the 2 seat track covers.
82711F
27.REMOVE WIRING HARNESS CLAMP (for Front Passenger Side)
Disengage the 2 claws to remove the wiring harness clamp.